Panel to protect walls from impacts and scratches vinyl WG 154 mm wide, length 4 r.m., light gray

Vinyl panels of light gray color (color No. 41) to protect walls from scratches and bumps are often used in commercial and industrial premises, such as hospitals, schools, offices and warehouses. They can also be useful at home, especially in places where there is a high risk of damage to the walls (for example, in the garage or in the kitchen).

Advantages of vinyl panels:

• Strength and Durability: Vinyl is resistant to bumps, scratches and humidity, which makes it a durable material for protecting walls.
• Easy to install: Vinyl panels are usually easy to install, requiring minimal skills and tools.
• Cost-effective: Compared to other materials such as wood or metal, vinyl is usually more economical.
• Design variability: There are many color and texture options that allow you to integrate vinyl panels into various interiors. We can produce any color according to the RAL table when ordering from 200 m.p.
• Hygienic and easy to care for: Vinyl is easy to clean and disinfect, making it ideal for places where high standards of hygiene are required.

Installation:

Installing vinyl panels is relatively simple and can include the following steps:

• Determine the installation height of the wall covering.
• Wall preparation: Removal of old facing materials, priming and leveling of the surface.
• Measurement and marking: Accurate measurements and marking for the correct distribution of panels.
• Panel Trimming: If you need to trim the bump, use a mounting saw or a construction knife and a metal ruler (square).
• Make sure the wall is dry and clean.
• Remove all the irregularities of the wall, for best results.
• Mounting: The panels can be attached to the wall with glue, screws or special fasteners.
• Before applying the adhesive, wipe both sides of the bump to make sure that there is no dust and dirt on the surfaces.
• Apply the glue only to the wall surface, use a D2 or B3 spatula to distribute the glue. It is recommended to use a water-based contact adhesive (KIILTO EXTRA, DENLAKS TK-580). Consumption of 300-350 g of glue for each 1 m2.
• Allow the glue to harden, under normal conditions it will take from 10 to 15 minutes. However, the duration of curing depends on temperature and humidity.
• Important: Read the glue specification or other adhesives before applying.
• Place the bump sheet on the wall, align and press it in place manually.
• Roll up the bump strip using a pressure roller. Start rolling in the center of the sheet and move towards the edges. After installation, remove excess glue.

With proper installation and maintenance, vinyl panels can serve for a long time, effectively protecting the walls from damage.