Bitumen mastic on water for waterproofing and gluing thermal insulation boards Izoplast W-KL, 20 kg ADW

Izoplast W-KL is a water-based bitumen-rubber mastic for creating lightweight, seamless waterproofing coatings. For gluing foam boards, expanded polystyrene (EPS, XPS) and mineral insulation to concrete, brick and plastered surfaces.

Application:

To create seamless, thick-layer elastic and moisture-resistant coatings, both on horizontal and vertical surfaces
For bonding rigid thermal insulation boards made of EPS or XPS styrofoam
To create waterproofing resistant to aggressive weather conditions

Advantages:

Easy to use
Does not contain solvents
High adhesive properties
Creates a seamless insulation layer
High adhesion to mineral surfaces
Seamless waterproofing of vertical and horizontal surfaces

Instructions for use:

Mix before use. The surface should be smooth, free of dust and dirt. The concrete surface must be primed with IZOPLAST DYSPERBENT, or, if necessary, apply the necessary waterproofing layer. To use as a waterproofing layer, apply the thoroughly mixed mass of Izoplast W-KL to the surface with a brush, spatula or roofing brush. For gluing plates made of foam or expanded polystyrene, Izoplast W-KL is applied to the plate in strips 4 cm wide and 1.5 to 5 mm thick around the perimeter with an interval of 30 cm, or 20 points with a diameter of 5-10 cm per 1 m2.

Application Notes/Restrictions:

Observe the safety and health regulations during the work. Use protective gloves, clothing, glasses. In case of contact with the skin, rinse with plenty of soap and water. In case of contact with eyes, rinse with plenty of water and consult a doctor. Work with IZOPLAST W-KL should be carried out in windless weather without precipitation at ambient temperatures from 5 ° C to 25 ° C.