Water-based bitumen emulsion Izoplast R-W, 10 l ADW

  1. Protex
  2. Waterproofing
  3. Water-based bitumen emulsion Izoplast R-W, 10 l ADW

Water-based bitumen emulsion Izoplast R-W, 10 l ADW

Bitumen emulsion is intended for priming the surface and performing light water-based waterproofing, 10 l

0
Svetlana Fedchenko
0

Bitumen anionic emulsion Izoplast R-W is designed for priming the surface and performing "light" waterproofing before laying rolled and liquid waterproofing materials (Izoplast B-W, Izoplast 2K-W) on any mineral surfaces, as well as for protecting wooden elements.

Advantages of the material:

Ready for use
Does not contain solvents
Can be applied to dry and wet surfaces
Dries quickly
Penetrates deeply into the base
Enhances the adhesion of the base to insulating materials
Protects the base from the effects of weather conditions
Protects the bases from the effects of chemicals and salts
It can be used in contact with expanded polystyrene, mineral wool and wood

Application areas:

To create moisture- and water-proof insulation coatings on vertical and horizontal concrete surfaces
In private construction and in large-scale infrastructure facilities
To protect wooden products and elements (poles, fences) from moisture
To create a thin layer of waterproofing

Surface preparation:

To create a reliable insulating coating, the surface must be smooth, without bumps, depressions and cracks. If there are voids and/or cracks on the surface, they must be repaired with appropriate repair compounds.

Before applying the material, the surface must be cleaned of dirt, dust, oils and other substances that interfere with adhesion. It is necessary to use Izoplast R-W on fresh concrete surfaces after the end of the concrete drying period.

Preparation of the material:

Mix the material thoroughly before use.
To be used as a primer, Izoplast R-W must be diluted with clean water in a ratio of 1:1.

Application of the material:

IZOPLAST R-W is applied with a roofing brush or a brush with stiff bristles. Each next layer must be applied after the previous one has completely dried. The drying time depends on the temperature and humidity of the environment and the substrate (up to 6 hours).

Recommendations for use, storage and transportation:

Store and transport at a temperature not lower than 5°C.
The tool after use with IZOPLAST R-W should be washed with water immediately after use, after drying it can only be cleaned mechanically.

Surface preparation:

To create a reliable insulating coating, the surface must be smooth, without bumps, depressions and cracks. If there are voids and/or cracks on the surface, they must be repaired with appropriate repair compounds.

Before applying the material, the surface must be cleaned of dirt, dust, oils and other substances that interfere with adhesion. It is necessary to use Izoplast R-W on fresh concrete surfaces after the end of the concrete drying period.

Preparation of the material:

Mix the material thoroughly before use.
To be used as a primer, Izoplast R-W must be diluted with clean water in a ratio of 1:1.

Application of the material:

IZOPLAST R-W is applied with a roofing brush or a brush with stiff bristles. Each next layer must be applied after the previous one has completely dried. The drying time depends on the temperature and humidity of the environment and the substrate (up to 6 hours).

Recommendations for use, storage and transportation:

Store and transport at a temperature not lower than 5°C.
The tool after use with IZOPLAST R-W should be washed with water immediately after use, after drying it can only be cleaned mechanically.

Related materials

© "Protex-S" LLC2021 | Website created by MD Design