Spring Spring Clamp for formwork Corrosis

Spring clamp for ANAS formwork

Chiroz - a spring clamp for reinforcement, which allows you to quickly fasten formwork panels and withstands loads of up to 2 tons. Suitable for reinforcement from 6 to 10 mm. Allows you to abandon or significantly reduce the use of tie screws, formwork nuts and clamps. For convenience, it is recommended to use a clamp wrench for chiroz. The spring clamp is easy to use, significantly saves time during the assembly and disassembly of formwork for foundations, monolithic belts, column walls and concrete stairs.

Advantages of spring clamp:

• Simplicity and ease of use

• Saving installation time

• Saving on consumables

• Withstands high loads

• Works with fittings with a diameter of 6 to 10 mm

• Reusable

Recommendations for use:

To install the spring clamp, it is necessary to bring the ends of the reinforcement to the outside of the formwork panel for a length of about 15 cm and tighten with a clamp wrench for the chirose. After completing the work, removing the chirose and dismantling the formwork, it is necessary to cut off the ends of the reinforcement.

Clamp characteristics:

• Weight: 0.3 kg

• Plate size: 105*72 mm

• Rebar diameter: 6-10 mm

• Plate thickness: 3.0 mm

• Load: up to 2 tons

• Material: hardened steel