A formwork clamp, a reinforced spring corrosis

Spring clamp for formwork reinforced

Reinforced formwork clamp is a spring clamp for reinforcement, which allows you to quickly fix formwork panels and withstands loads of up to 3 tons. The clamp is put on any reinforcement with a diameter of 6, 8 and 10 mm. The reinforced version is distinguished by a galvanized body, a rigid spring, a large weight and an enlarged support area of the spring clamp plate. It allows you to fix formwork panels made of plywood and timber without the use of tightening screws and nuts, with the teeth of its disk mechanism. This is an indispensable reusable element for fastening formwork, which prevents its opening during the construction of a monolithic frame structure.

 

 

 

 

 

• Easy and convenient to use
• Saving money and time
• Reduces labor costs
• Speeds up the formwork installation process
• Significant savings on the installation pipe and cone clamps
• Withstands loads up to 3 tons.
• Suitable for rebar from 6 to 10 mm.
• Thanks to the clamping tongue, it prevents the reinforcement from being skewed
• Reusable

Installation procedure and rules:

To install a chiroz, which is a kind of clamp, it is necessary to bring the reinforcement out of the formwork panels for a length of about 15 cm through special holes and tighten with a special wrench. The ends of the reinforcement are simply cut off during the dismantling of the formwork and removal of the chiroz.

• Weight: 0.45 kg.

• Plate size: 110*75 mm.

• Reinforcement diameter: 6-10 mm.

• Plate thickness: 4.0 mm.

• Load: up to 3 tons

• Material: hardened steel