The nut is galvanized for formwork, 90 mm in diameter.

A coupling nut for fixing the shields from the outside to prevent their deformation during concrete pouring. The coupling nut is a component for the coupling screw, anchor rod, universal connector, pin. It is tightened using a wrench and using a mount that fits the formwork system assembly. The elongated sleeve prevents the shields from shifting during vibrations. The nut's bearing area is increased by using washers of different sizes. Made of silumin.A coupling nut for fixing the shields from the outside to prevent their deformation during concrete pouring. The coupling nut is a component for the coupling screw, anchor rod, universal connector, pin. It is tightened using a wrench and using a mount that fits the formwork system assembly. The elongated sleeve prevents the shields from shifting during vibrations. The increase in the support area of the nut is achieved by using washers of different sizes. Made of silumin. The coupling nut is necessary for fixing the shields from the outside to prevent their deformation during pouring concrete. It acts as a support, has a diameter of 100 mm. The configuration allows you to tighten its nuts both with a wrench and with the help of a mount that fits the formwork system assembly. The elongated sleeve prevents the shields from shifting during vibrations. The nut is made of high-quality plastic, which can withstand loads of up to 4 tons, is resistant to the aggressive effects of concrete and lubricating mixtures.

Main characteristics:

• for tie screw
• anchor rod
• universal connector
• kingpin