Spiked membrane SNTDRAIN EKL 400, (roll 2X20) for foundation and drainage protection

The spiked membrane 400 SNTDRAIN EKL is used in multi-storey basements, garages, bridge abutments, tunnel supports, in individual projects of drainage and drainage systems of roads, bridges, railway embankments. It is used in places where high compressive strength, impact strength and resistance to surface loads are required.It is also used for drainage and drainage of roads, bridges, railway embankments. The spiked membrane 400 SNTDRAIN EKL protects the outer bitumen insulation layer of foundations and engineering structures from possible mechanical damage during backfilling, and also protects the insulation during subsidence of the soil.

SCOPE OF APPLICATION:

• Protection of waterproofing of buried parts of buildings during the filling of the pit with soil
• Protection of the foundation plate from capillary moisture 
• Rehabilitation of wet walls
• In operated flat roofs, in green roofs
• Replacement of concrete preparation
• Protection of basements from penetration of radon gas
• An additional layer of waterproofing
• Water drainage and water pressure relief
• Density 400 g/^m2
• Elastic, waterproof, durable
• Color - black

MAIN ADVANTAGES:

• Drainage of water from the structure of the building and allows it to flow freely into the drainage pipe.
• Minimizes the risk of damage to the waterproofing layer under the membrane during backfilling.
• Cuts off waterproofing in the construction of the floor on the ground.
• The spikes between the membrane and the basement wall form an air gap that protects from underground gases and keeps the surface dry and protects from moisture.
• An inexpensive alternative to thin concrete for the foundation, including the following advantages: faster installation, which does not require additional equipment.
• Does not pollute the environment, can come into contact with drinking water.
• Distributes the loading evenly over the surface.
• It can be used for horizontal and vertical laying.

INSTALLATION AND STORAGE INSTRUCTIONS

Vertical Application:

1. Remove dust and debris from the surface.
2. Place the sheet on the surface so that the spikes face the wall.
3. Secure the sheets to the wall along the top edge of the base with a fastener.
4. The overlap of the sheets should be at least 20 centimeters.
5. If necessary, the connection can be fixed by hot air soldering or self-adhesive tape.
6. Application temperature: - 5°C to 30 °C

Horizontal Application:

1. Remove dust and debris from the ground.
2. Lay the sheet on the area with the spikes to the ground.
3. The leaves overlap with each other by at least 30 centimeters.
4. If necessary, the connection can be fixed by hot air soldering or self-adhesive tape.
5. Application temperature: - 5°C to 30 °C